Avangard 24 is a new concept of a cast-iron heat-accumulating sauna stove with direct heating of the charge.  The body is modular, assembly takes place from the bottom up, the modules are connected according to the tongue-and-groove system.

Mass of the steam evaporator in the Avangrad 24 oven – 56 kg and it is heated by direct contact with the flame. The steam evaporator has 2 surfaces with an increased working area – from below there is heating by fire, and from above water is given for steam. To increase the evaporation area and heat the first layers of stones, high spikes are cast on the stove.

A flame divider is installed under the stove on 3 stops, it divides the flame into 3 streams and directs first to the side parts of the body for intensive heating of the walls and convection heating of air in the steam room. For this, convection ribs are located on the outer surfaces. Then the flame passes through the ledges to the exit to the chimney, heating the stove.

The heater allows you to install various Hephaestus starter modules together with the slide block.

Package includes:

Sauna stove Avangard 24

Starting nozzle

Stainless steel ash box steel

Round grid

Sealant "Titan" up to 1500С-1 pc.

Warranty certificate (instruction manual)

Technical details:

Steam room volume, m3 - 24

Equipment - under the lining

Type of fuel - firewood

Oven door view - small

Material - heat-resistant cast iron grades CH1, CH2, CH3

Weight, kg - 179

Steam room mode - Russian sauna

Removal of the portal, mm - 230

Chimney diameter, mm - 112

Firewood length, cm - 38

Furnace dimensions, (LxWxH) mm - 430х680х630

Mesh dimensions, (LxWxH) mm - 560х560х680

Stones capacity, kg - 150

Tunnel material - cast iron