 (7).png "SaunaBee ENG"){kind=logo}
Avangard 40 is a new concept of a cast iron heat storage sauna stove with direct charge heating.
The casing is modular, assembly takes place from the bottom up, the modules are connected according to the tongue-and-groove system.
The weight of the steam evaporator in the Avangrad oven is 30 - 56 kg, and it is heated by direct contact with the flame. The steam evaporator has 2 surfaces with an increased working area - from below it is heated by fire, and from above it gives in water for steam. To increase the evaporation area and heat the first layers of stones, high spikes are cast on the stove.
A flame divider is installed under the stove on 3 stops, it divides the flame into 3 streams and directs first to the side parts of the body for intensive heating of the walls and convection heating of air in the steam room. For this, convection ribs are located on the outer surfaces. Further, the flame passes through the ledges to the exit to the chimney, heating the stove.
The heater allows you to install various Hephaestus starter modules together with a slide block.
The kit includes:
sauna stove Vanguard 40
starting nozzle 115
heater cover
2 steam guns
ash drawer structural steel
sealant "Titan" up to 1500С-1 pc.
warranty passport (operating manual)
Steam room volume, m3: 40
Equipment: under the lining
Type of fuel: firewood
Material: heat-resistant cast iron grades CH1, CH2, CH3
Oven door view: panoramic
Weight, kg: 306
Steam room mode: Russian sauna
Removal of the portal, mm: 200
Firewood length, cm: 50
Chimney diameter, mm: 130
Furnace dimensions, (LxWxH) mm: 760х500х930
Glass size, (WxH): 335x280
